Floors in Kankurgachi take a beating  dust, foot traffic, hard water and the odd harsh cleaner. Marble Polishing here is a mechanical process, not a floor cleaner with a shine claim: we cut back the worn layer, work through finer abrasives and only then buff the surface up.
The work runs in stages: diamond grinding in graded grits, honing to clear the scratch pattern, then a powder or crystallization pass that brings the stone to an even gloss. We use single-disc and three-disc floor machines, diamond abrasives from 30 to 3000 grit, buffing pads and a neutral pH cleaner. Between stages the slurry is cleaned out completely, because leftover grit is what leaves swirl marks on a finished floor.
Most of our work in Kankurgachi is on Makrana, Katni, Italian, white and green marble, along with Kota stone and terrazzo. Each stone behaves differently  Makrana and Italian marble take a high gloss, Kota stone prefers a honed matte finish, and granite needs its own abrasive bond. We match the pad sequence to the stone instead of running one programme on every floor.
Marble Polishing in Kankurgachi generally falls in the Rs.10-15 per sq.ft range. Three things move that number: total area, how deep the scratches and stains are, and whether joints need epoxy filling or tiles need levelling. We measure on site, give the rate in writing, and the final bill follows that rate unless you add scope.
A polished floor stays glossy if it is mopped with a neutral cleaner and plain water. Phenyl, acid and hard-water mopping are what kill shine fastest. In high-traffic areas a light maintenance polish every 12 to 18 months works better than waiting for the surface to go completely dull again.
Send the carpet area and two photographs on WhatsApp and we will give an indicative rate the same day. A site inspection in Kankurgachi is free, and there is no obligation to book after it.
Will the floor look new again?Where the dullness is surface wear, yes  most floors come back close to their original finish. Stains that have gone into the stone body, chips and cracks can be improved but not always erased, and we say so at inspection rather than after billing.
Do you use acid?No. Acid brightens marble for a week and then eats the polish. We work with diamond abrasives and pH-neutral chemistry.
How soon can we walk on it?Straight after a dry polish. Where epoxy filling or a sealer is used, we ask for four to six hours of drying time.
There are no products to list in this category.
Ansari Marble polishing laying specializes in Service Provider, serving customers across . Located a...
Shadab Marble design flooring specializes in Service Provider, serving customers across . Located at...
Jahurul Marble & Tiles Fitting & Material Contractor specializes in Service Provider, serving custom...
Arham marble polish specializes in Service Provider, serving customers across Kolkata, Rajarhat. Loc...
Allauddin tiles and marble contractor specializes in Service Provider, serving customers across . Lo...
Akash Floor Polishing is a trusted service provider, dedicated to delivering high-quality flooring a...
Sunil Pandit Marble Installation Polishing Services specializes in Service Provider, serving custome...
Refer Service specializes in Service Provider, serving customers across . Located at No. GC-23, Nar...
