Marble Polishing in Supertech

Marble Polishing in Supertech

Marble, granite and tile floors all dull for their own reasons, and they need different pads and compounds to look right again. Our work in Supertech starts with a look at the actual surface before we promise anything or quote a rate.

Why floors in Supertech lose their shine

Floors in Supertech dull faster than most owners expect. Fine construction dust and street grit act like sandpaper under foot, and repeated mopping with ordinary detergent leaves a cloudy film. Acidic cleaners and tea or coffee spills etch the surface, which is why the damage shows up as white or grey patches rather than simple dirt.

What a proper marble polishing involves in Supertech

The work moves from coarse to fine. We start with a coarse diamond pass to take out scratches and light unevenness, then step through progressively finer pads to remove each previous scratch pattern, and finish on a fine pad for the gloss. Crystallisation or a silicate sealer is added only if the stone suits it and you want the extra protection.

How the job runs, step by step

1. Free inspection of scratches, joint gaps, hollow patches and any old wax or sealer.
2. A small test patch so you can see the achievable finish before the full area is done.
3. Masking of skirting, walls and furniture edges before the machines start.
4. Grinding or sanding where the surface is uneven, then the full polishing sequence.
5. Cleaning of joints and corners by hand, with the slurry vacuumed as we go.
6. A walk-through in daylight at handover, with anything uneven pointed out honestly.

Where we work in Supertech

Standard work in Supertech runs 25-40 minutes of machine time per 100 sq.ft., so most flats are finished in a day.

What it costs in Supertech

As a working band, a light buff and maintenance polish usually runs Rs.5-15 per sq.ft., a full diamond polish Rs.15-25, and a deep diamond job with crystallisation or sealing Rs.25-35. Stairs, counters, wall cladding and very large halls are quoted separately. You get the band in writing before work starts, and the final figure follows a look at the floor.

Questions we are asked in Supertech

Will polishing remove deep scratches? Light scratches and dull patches come out well. Very deep gouges, chips and long-standing stains may still leave a faint mark, and a badly damaged tile sometimes needs filling or replacement. We tell you what will not come out before you agree to the work.

Is it dusty or smelly? We work wet where the stone allows and use extraction where it does not. Slurry is bagged and skirting is wiped before we leave, so the mess stays low and the smell is minimal.

How long does the finish last? Two to three years in a home before a light maintenance pass, and eight to twelve months in busy offices or hotels. A sealer and the right cleaner both stretch that.

Book a free site inspection in Supertech

Call or WhatsApp +91-86070 01043 with the approximate square feet, your locality and a photo of a dull area and a bright one. We will give you a realistic band the same day, with no obligation to book.